Meets or Exceeds Standards for ANSI 250.4 and ANSI 250. It is recommended that finish paint (top coat) be applied after installationġ61 (cylindrical lock), 86 Edge (mortise lock), Deadbolt, RPD (blank edge, panic reinforced)Ĭontinuous Hinge Application (Undersized Width), Exit Device Trim, Lite and Louver Cutouts Heavy Gauge Door Closer and Hinge Reinforcementsġ4-Gauge Inverted Top and Bottom Channels, Optional Flush Top Capįactory-Applied, Baked-On, Rust Inhibiting Gray Primer (No Special Color Options) – Not intended to be a finish coat. Square Hinge and Lock Edges (Beveled Edges Available) – Full Height, Epoxy Filled Mechanical Interlock Edges Standard Widths up to 4'0", Height to 8'0" (Custom Sizes Available) Non-Handed Design Reversible Hinge Plates Remove tape and plastic and reinstall mail slot hardware. Once hardened, trim excess spray foam flush. Fill with spray foam (get a spray foam that sets up quick if you can). Tape and plastic off the area around mail slot. Heavy Duty, SDI Level 2 – 18-Gauge Steel Face Sheets – (16 Ga. Remove the mail slot hardware, should be a few screws on each side.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |